Please visit www.militarmorons.com for a detailed write up and additional photos.
MOLLE/PALS compatible via two included long MALICE clips. Can be mounted on webbing or belts up to 2.75" wide via two included short MALICE clips. Two sewn in sets of overlapping Velcro straps can be used to mount the GPS Pouch vertically to the shoulder strap of a pack, horizontally to a belt, or horizontally to a MOLLE/PALS platform.
The GPS Pouch is designed for the Garmin GPSMAP 60 series (60, 60CS, 60CSx) units which are about 5.25" tall x 2.25" wide x 1.5" deep with an antenna sticking up another 1.5", but it will fit any other GPS unit that fits within those dimensions. It will also accommodate the Oregon and Colorado series of GPS units and any other smaller types. Although not originally designed for it, we've also tested the pouch to fit the Garmin Rino 655T. The pouch will fit most other devices such as mobile phones, digital music players, digital cameras, two-way radios, etc.
The front and rear panels feature internal HDPE plastic stiffener sheets to protect the GPS unit from bumps and sharp objects. The sheets spread an impact over a wider area offering better protection than soft thin padding alone. The HDPE stiffener sheets also prevent buttons from being pressed unintentionally. Behind the HDPE sheet in the front panel is a thin layer of EVA foam for additional padding.
At the top of the pouch is an opening with an overlapping elastic cover that allows the top antenna of GPS units or two-way radios to protrude. This opening can also be utilized to route headphones or other wires.
The dual zippered opening runs the full length of the top and sides of the GPS Pouch allowing the pouch to be opened out and down. This clamshell opening is designed to hold the GPS unit horizontally. An internal paracord drawstring can be used to adjust the exact angle at which the pouch opens when fully unzipped. From 1° to 90° and anywhere in between. Each end of the paracord drawstring goes through two small eyelets at the top of the back panel of the pouch and then they’re knotted. These knots can be retied to lengthen or shorten the cord. A drainage grommet at the very bottom of the pouch body allows drainage of water, sand, and other unwanted debris.
Included with the GPS Pouch, it features a clear plastic front with elastic straps on the sides to securely retain the GPS unit in the pouch and provide additional protection for the screen. The clear screen is 2.5" tall x 2.25" wide and still allows touch screen devices to function. The sleeve is elastic so it will accommodate a variety of devices, but will be looser or tighter depending on the dimensions of that device. The sleeve is backed with hook Velcro so it can be secured anywhere on the loop Velcro lining on the front panel of the pouch.
Although designed for GPS units, the GPS Pouch and its features work well with other devices such as mobile phones, digital music players, digital cameras, two-way radios, etc. If an item does not fit in the retaining sleeve: adhesive Velcro can be added to the back of that item which would allow it to be secured to the loop Velcro lining the interior of the front panel.
Stocked in Black, Coyoteish, MultiCam, SDU Grey, Sewer Green. Available custom order colors: 3 Color Desert, Brown, Foliage Green, Khaki, Navy Blue, Olive Green, UCP, and Woodland. Please email us at firstname.lastname@example.org for all custom color inquiries.