MOLLE/PALS compatible via three included long and short MALICE clips. Can be mounted to four or five columns of PALS webbing.
At the very top and bottom corners on the rear of the carrier are Tri-glide and Looploc attachment points for our Emdom H2O Hydration Carrier Should Strap System (Included). These four attachment points can also be used to mount the Vehicle Hydration Carrier to our Emdom/MM Battle Suspenders (sold separately) via additional hardware (NOT included).
Exterior front and sides:
Front features 6 rows x 5 columns of color/pattern matched PALS webbing. Each side features 4 rows x 2 columns of color/pattern matched PALS webbing. At the top is a 5.5” x 3” loop Velcro area integrated with the top two rows of PALS webbing. There are four 1” tab loops on the front for use as tie-downs or lash points. Integrated into the front of the carrier is a full length general purpose pocket with a zippered opening at the very top and another half way down. Zippered openings are covered, protecting them from damage and the elements.
Exterior back and bottom:
Back features full MOLLE/PALS webbing grid for mounting to a compatible platform via included set of long and short MALICE clips. Drainage grommet at the very bottom of the pouch allows drainage of water, sand, and other unwanted debris.
Main compartment opening:
Dual zippered opening is protected from damage and the elements by full length cover flap. Each zipper pull features two snaps which ensure a secure closure when snapped together. At the very top towards the back of the carrier is an elastic flap covered hydration tube port which will accommodate most mouth pieces and attachments.
Main compartment interior:
The front portion features a 4.5" x 5" zippered mesh pocket for reservoir connectors, spare bite valves, cleaning tablets, etc. Behind the mesh pocket is a 4” x 4” loop Velcro panel for storing ID/IFF patches and markers. The back portion of the interior features a mesh reservoir pocket with an elastic rim. Towards the bottom is a 3” wide elastic compression strap. At the top is a paracord loop for hanging a reservoir.
The Vehicle Hydration Carrier is designed to accommodate a 70oz/2L reservoir (NOT included). However some 100oz/3L reservoirs can fit, albeit tightly.